Confetti Launcher Instructions
It's easy, and takes less than a minute!
The launcher in this illustration may be smaller than the item you are looking at, but the basic principals are the same for most of the Co2 launchers.
If your CO2 confetti launcher is 1 inch in diameter or larger (all except the confetti gun), then it is recommended that you use a lifting cup, available from us. The Lifting cup will enable an evenly distributed push behind your confetti load, enabling it to shoot higher and further without the CO2 "whooshing" through the confetti.
To Install, Push the lifting cup into the bottom of the launcher using the ramming rod (provided for free with most launchers). Make sure the cup is as straight as possible, with none of the edges tilting up.
 |
 |
Next, Load
in your confetti and/or streamers. Push them in snugly - be careful
not to jam them in too tightly or the confetti may become "clogged"
or the streamers might not open properly. Use separator discs
between streamer loads to avoid entanglement.
Stacked confetti
will travel further, and you can fit more confetti into the launcher
this way. Loose confetti will not travel as far and will take
longer to to load, but is more economical.
To Load Streamers,
remove and discard the outer wrapping and unravel a small amount.
This allows the streamers to unfurl properly when launched.
For added height,
a back pressure cap may be used. To install: place cap over end
and neatly tape two full turns around the side of the barrel
and cap using masking tape. Press to form a tight seal. The tape
should be distributed equally against the launcher and the cap.
Too much masking tape or use of duct tape can cause a dangerous
condition.
Arming: Do
not arm launcher until ALL other preparations are finished. Each
individual should be responsible for loading their own device.
Lift lever up and screw the CO2 cylinder into the threaded hole
on the valve. If the unit is a larger one, it may require two
cylinders. Caution: DO NOT point at yourself or anyone else during
or after installation of CO2.
Firing: To
operate this device you must forcefully and quickly push
down the lever trigger. If you are using a hand held unit, use
both hands to hold onto unit while firing.
Cautions:
1. Never point
the muzzle directly at a person or animal - always aim up over
people's heads.
2. Never use
any foreign material in your confetti launcher.
3. CO2 containers
get extremely cold after firing, do not remove without glove
or rag - or wait a few minutes for CO2 to warm up.
Misuse is dangerous.
Star Light and Magic is not responsible for accidents that occur
while using this product.
